Electric counterbalance forklift is widely used in warehousing, manufacturing and cargo handling scenarios, as it carries heavy loads stably without extra emission pollution. Proper daily basic maintenance is the core premise to reduce unexpected shutdowns, avoid potential safety hazards during operation, and cut long-term operating costs. All maintenance work should be carried out in accordance with the official operation and maintenance manual, no unauthorized disassembly of core components is allowed to avoid unnecessary damage.
The first essential part of maintenance basics is the pre-shift daily inspection. Before starting each work shift, operators should conduct a full check of the whole vehicle: test the braking system to confirm it responds sensitively and stops steadily, check the mast chain tension and surface wear condition, observe the wear degree of solid or pneumatic tires and confirm no embedded sharp debris, check the electric connection parts of the power battery to make sure no loose or corrosion traces, and test all functions of the control handle, horn and light system one by one. Any abnormal sign found in the inspection should be reported to the management immediately, and do not operate the vehicle with hidden troubles.
Rational battery care is the key point for electric forklift maintenance, since the power battery determines the whole performance and service life of the equipment. Operators should follow the standard charging specification, avoid overcharging or deep over-discharging of the battery. Clean the dust and possible electrolyte residue on the battery surface regularly, keep the ventilation holes of the battery unobstructed, and never cover the battery with sundries during charging. If the forklift will be idle for more than 7 days, carry out supplementary charge every 10 to 14 days to keep the battery at proper state of charge, to avoid permanent capacity loss caused by long-term power deficit.
Regular lubrication of mechanical components and standardized post-operation storage are also non-negligible basic maintenance contents. Follow the specified maintenance cycle to inject proper amount of qualified lubricating grease at all hinge points of the mast, steering shaft and bearing positions, and clean the sundries around the oil nozzle before lubrication to prevent impurities from entering the internal structure of components. After finishing daily operation, park the forklift on a flat designated area, lower the forks to close to the ground, pull the handbrake tightly, and turn off the main power switch completely. Do not park the vehicle in long-term direct sunlight or extremely humid environment, to slow down the aging speed of electronic circuits and rubber parts.

Sticking to the above basic maintenance steps can effectively extend the service life of the counterbalance forklift, and bring safer and more efficient operation experience for handling work. We are Jianshu New Energy, focusing on high-quality BYD electric forklift supply and related supporting services. If you have any demand for electric forklift products or maintenance consultation, you can contact us via [email protected].
.jpg)
