Proper preparation is the core premise to ensure the stable operation of electric forklift, extend the service life of equipment and avoid unnecessary safety risks. The whole preparation process can be divided into three core stages, including site environment preparation, equipment status check and operator readiness, which can be executed step by step without redundant complicated procedures.
First of all, complete the site environment matching preparation before the equipment enters the operation area. You need to check the flatness of the ground in the whole operation route, confirm that the ground load bearing capacity meets the passing requirement of the electric forklift, remove the scattered sundries, sharp hard objects on the walking path, and set up obvious warning signs for the working area to remind irrelevant personnel not to enter by mistake. It is also necessary to plan a dedicated charging area with good ventilation, no flammable and explosive materials placed around, and the ground of the charging area can be paved with non-slip and insulating material to avoid hidden dangers during battery charging process.
Next, complete the comprehensive pre-use inspection of the electric forklift itself. First check the battery power level and the connection status of the battery terminal, make sure there is no loose connector, no obvious rust or leakage phenomenon at the connection position. Then check the tire status, confirm the tire pressure is within the specified range, and remove the stones, iron filings and other foreign matters stuck in the tire gap. Then test all operation functions, including the flexibility of steering lever, brake pedal and lifting system, verify that the warning light, horn, lighting device and reverse prompt function can work normally.

Then complete the operator's preparation work. The operator needs to receive formal standardized operation training, fully master the rated load parameter, maximum lifting height and other core attribute of the electric forklift, and strictly follow the operation specification to avoid overload operation. Before starting work, the operator needs to wear complete labor protection equipment, confirm the whole operation route of the day in advance, and mark the key sections with dense pedestrian flow or narrow passage in advance to make corresponding operation plans.

After finishing all the above steps, you can carry out 5 to 10 minutes no-load test run of the electric forklift, test the full performance of steering, braking, forward and backward driving, and goods lifting function, and put the equipment into formal operation only after all indexes are confirmed to meet the normal requirements. If you need professional support related to electric forklift, Jianshu New Energy, which focuses on high-quality electric forklift products, can provide you with full range of tailored solutions, you can contact us via [email protected] for further consultation.
