As core material handling equipment for narrow-aisle warehouses, the reach forklift is widely used in scenarios that require high-lift goods storage and limited operation space, and a standardized practical operation system can help give full play to its use value while reducing unnecessary wear and safety risks.
The first core step of the practical approach is to complete pre-operation inspection before each shift. Operators need to walk around the vehicle to check the integrity of the body structure, no obvious deformation of the forks, flexible reset of the operation handle, firm fixing of the overhead guard, and sufficient remaining battery power to support the planned operation volume of the shift. These basic checks only take 2 to 3 minutes, which can effectively avoid sudden shutdown failures during the operation process, and reduce the potential safety hazards caused by hidden equipment problems.
The second part is scenario-adapted operation specifications. When the vehicle travels in a narrow aisle, operators need to reserve enough safety margin on both sides of the body, avoid sharp steering at high speed, and remind surrounding operators of the passing route in advance. When lifting goods to a high shelf, keep the vehicle in a horizontal static state first, and do not carry out large-scale lateral movement of the vehicle when the load is lifted above 3 meters, which can keep the operation stable and reduce the risk of goods falling. It is also necessary to strictly refer to the load curve mark on the vehicle body, and do not operate with overloaded load under any lifting height, so as to protect the normal service life of the hydraulic system and vehicle structure.

The third part is daily low-cost maintenance practices. After each operation, park the vehicle in the designated charging and storage area, lower the forks flat to the ground, pull the handbrake, and turn off the power supply in time. For new energy electric reach forklifts, try to avoid discharging the battery to a nearly empty state before charging, and supplement the power in time when the remaining power is lower than 20% to extend the cycle life of the power battery. Regularly clean the accumulated dust and debris at the heat dissipation opening of the body every week, to ensure that the core electrical components can maintain a good heat dissipation state during long hours of continuous operation.
.jpg)
As a professional supplier focusing on new energy forklift solutions, Jianxin New Energy is dedicated to providing supporting operation guidance and after-sales service for BYD electric forklifts. If you have related demands for model selection, operation training or scenario customization, you can send an email to [email protected] to get targeted professional support.
