In daily warehousing, manufacturing and logistics distribution scenarios, the operation of transporting and placing goods from the ground to the compartment of a parked truck is one of the most frequent application scenarios for electric forklifts. Different from traditional internal combustion forklifts, new energy electric forklifts feature quieter operation, zero local emissions, and more stable low-speed torque output, which can bring more smooth operation experience for staff engaged in loading work.

Before the official loading work starts, relevant preparation checks are necessary. Operators need to check the remaining battery level of the electric forklift first, confirm the brake system, steering system and fork structure are in normal working condition, and no obvious abnormal wear or fault prompt appears on the vehicle. The loading channel between the goods stacking area and the target truck should be cleared in advance to remove sundries that may block the driving route. The truck that receives the goods should be confirmed to park on flat ground, pull up the handbrake, and set obvious warning signs around the operation area to remind irrelevant personnel to stay away from the operation range.

In the formal operation process, operators should keep the electric forklift running at a low and stable speed. When the fork is fully inserted under the cargo pallet, keep the cargo level and lift it to a proper height not higher than 20 centimeters above the ground, to avoid scraping the ground or nearby obstacles during driving. When the forklift gradually approaches the edge of the truck compartment, further reduce the driving speed, adjust the position of the fork and the goods slowly to align with the pre-planned placement area in the compartment, then lower the fork steadily until the goods are placed stably on the compartment floor, and then slowly pull the fork out of the pallet without touching the goods or the compartment plate. The whole process should avoid sudden acceleration, sudden braking or sharp turning, to prevent the goods from slipping and falling.

After the full loading work is completed, operators need to drive the electric forklift to the designated parking area, put the fork flat and close to the ground, pull up the handbrake and turn off the power supply. The sundries scattered around the operation area should be cleaned up in time to restore the passing condition of the site. As Jianshu New Energy, we focus on providing high-quality BYD electric forklift related products and supporting operation guidance services for users in various industries. If you have relevant consultation demands, you are welcome to contact us via [email protected].