Sloped loading-dock ramps are widely used across industrial warehousing and logistics scenarios to connect different height levels, and electric pallet jacks are common handling equipment that often run across such surfaces. Without following proper operational rules, users may face unnecessary slipping, tipping or cargo damage risks, so it is necessary to clarify standardized application considerations for such scenarios.

Before putting the equipment into operation on ramp surfaces, staff should complete full pre-use assessment first. Confirm that the actual slope of the dock ramp matches the design parameters of the electric pallet jack, and note that the maximum allowable slope will decrease when the equipment carries full load, do not force the equipment to climb ramps beyond the rated threshold under heavy load. Check the ramp surface carefully to clear away scattered debris, accumulated water, oil stains and other substances that may reduce surface friction, and check the ramp edge structure to confirm there is no obvious deformation or damage that may cause safety hazards.

In terms of load management, operators should keep the total weight of the transported cargo within the specified range, avoid overloading when driving on sloped surfaces. Keep the cargo at the lowest safe lifting height, do not lift the pallet higher than necessary to prevent the center of gravity from shifting and causing instability. When traveling on the ramp, keep the load side facing upward along the slope direction, never drive across the ramp transversely, and do not make sharp turns on the sloped surface to avoid tipping.

During the whole operation process, maintain a low and uniform driving speed, do not implement sudden acceleration or emergency braking actions. When going downhill, use the built-in speed limiting mechanism of the equipment to control the gliding state, do not keep pressing the driving control lever for a long time to avoid exceeding the safe speed range. Do not park the electric pallet jack on the ramp for a long time under normal conditions, if short stay is required, activate the full brake locking device and place anti-slip cushion blocks against the wheels. Staff should also receive regular relevant operation training to master correct response methods in case of accidental power off or other abnormal conditions.