For all warehouse and logistics scenarios, the comprehensive competence of a fork lift hand directly determines the operation efficiency and on-site safety level of the whole working area, so mastering standardized operation essentials is a must for every relevant practitioner.

Before starting any new energy electric forklift, a fork lift hand needs to complete a full range of pre-operation inspection work first. First, check the remaining power level of the equipment to ensure it can support the scheduled daily work tasks. Then, test the flexibility of the braking system, steering system and lifting control lever, confirm there is no abnormal stuck or unresponsive situation. It is also necessary to check the surface condition of the forks, wheels and safety warning lights, and clear the sundries that may block the operation line in advance. During preparation, the operator should avoid wearing loose clothes or hanging accessories that may be caught by moving parts, and adjust the seat position and safety belt to a proper fixed state.

In the actual operation process, the fork lift hand shall strictly abide by the load limit specified by the equipment, and never attempt to carry over-weighted goods beyond the rated load. When driving on the work site, keep a proper safe distance with surrounding pedestrians, other transport equipment and stacked goods, slow down in advance when turning, passing through passages with limited height or low visibility. When moving goods, keep the forks at a low height about 10 to 15 cm above the ground, and avoid lifting the goods to a high position for long-distance driving. It is strictly forbidden for any personnel to stand or walk under the lifted forks to avoid accidental injury. When driving on a gentle slope, keep the load facing the upward direction, and do not turn sharply or slide down in neutral gear.

After completing the daily operation tasks, the fork lift hand needs to drive the electric forklift to the designated fixed parking area, lower the forks to the lowest position, pull up the hand brake, cut off the total power supply of the equipment, and make a simple record of the operation status and abnormal conditions of the shift.

As a professional new energy logistics equipment service provider, Jian Shu New Energy focuses on BYD electric forklifts, and can provide users with systematic operation training and full-cycle supporting services. If you have any related demand, you can send an email to [email protected] for consultation.