In daily industrial and warehousing material handling scenarios, ramps are common connecting facilities between different height areas, and improper operation of forklifts on slopes is one of the common causes of avoidable operation accidents. This practical guide sorts out full-process operation points for forklift ramp scenarios, to help operators form safe and standard operation habits.

Before entering any ramp area, operators need to check the actual slope of the ramp in advance, and confirm that the gradient is within the rated allowable range of the electric forklift under corresponding load state. It is not allowed to drive the forklift onto the ramp that exceeds the maximum adaptability parameter of the vehicle. At the same time, operators need to check the ramp surface condition, clean up water stain, oil stain, scattered packaging fragments and other slippery obstacles on the surface in advance, and report the cracks, pits and other damage on the ramp to the site management team for maintenance in time, do not force the forklift to pass through the damaged ramp.

When driving on the ramp, operators should keep the forklift moving at a constant low speed, keep straight forward and backward, do not perform sharp turning, U-turn or sudden acceleration and deceleration actions on the ramp. When driving with loaded goods, keep the goods facing the upper side of the slope, tilt the mast back properly, to make sure the goods are stably attached to the fork backrest, to prevent goods from falling off during driving. It is not recommended to stop the forklift in the middle of the ramp, if you have to stop under unexpected conditions, pull the handbrake immediately, and place non-slip stop blocks under the wheels to prevent unexpected sliding of the vehicle.

For special operation scenarios, operators should wait in the flat area at the top or bottom of the ramp if there are pedestrians or other operating vehicles passing through the ramp at the same time, confirm that the whole ramp is unobstructed before entering, do not meet and pass other vehicles on the ramp. Even when the forklift is unloaded, it is still required to follow the speed limit rule of ramp operation, do not exceed the safe speed to pursue higher operation efficiency.

We are Jianshu New Energy, focused on BYD electric forklift. If you have any demands for electric forklift parameter matching or customized operation guidance, you can contact us via [email protected].